Brother MW-260 - Manual (Page 19)

19
Precautions
Static commands
Static commands are valid only in the following modes;
MW-145BT/MW-260 ： raster mode
PJ-623/PJ-663 ： maintenance mode
Example: To statically change the template selection number to 10
1) Switch to maintenance mode.
ESC i a 01h (1Bh 69h 61h 01h)
2) Select template number 10.
ESC i X n 2 01h 00h 0Ah
(1Bh 69h 58h 6Eh 32h 01h 00h 0Ah)
3) Dynamically enter the P-touch Template mode.
ESC i a 03h (1Bh 69h 61h 03h)
Notes for using Bluetooth (only MW-145BT/MW-260/PJ-663)
When you are connecting the printer via Bluetooth, the printer may not start to receive the
data immediately after the port is opened. We advise to wait for an interval of 500 msec
before sending the print data to the printer .
If you normally close and re-open the Bluetooth port between prints, we would again advise
to leave 500 msec between the port being closed and re-opened.
Also, once you have sent the print data, and the printing process has begun, do not close
the port. Please ensure 32 bytes of data has been received by the printer, and then close
the port.