Brother MW-260 - Manual (Page 39)

17
^CC Change the prefix character
[ASCII] ^ C C n
[Decimal] 94 67 67 nd
[Hexadecimal] 5E 43 43 nh
[Parameters] 00h≤nh≤FFh
[Description]
· Changes the prefix character code.
n : Character code
· The default text string for the prefix character is “^”.
· This command is a dynamic command.
[Example]
· To change the prefix character from “^” to “_”, send the command shown below.
^ C C 5Fh (5Eh 43h 43h 5Fh)
(“_”)
· However, since the prefix character remains set to “_” if the machine is not later turned
off, then on, the initialize command, for example, will be “_II” instead of “^II”.