Sterlco ST500 Series Central Granulator - Manual (Page 59)

59
SETTINGS AND ADJUSTMENTS
SECTION 4-25
Setting and Adjusting the Chamber Pneumatic Cylinder
CLOSING THE REAR HATCH
Make sure no one is near the rear hatch during
operation.
Actuate the cutting chamber cylinder from the
pneumatic console by turning the switch to the
RAISE position. Hold the switch till the hatch stops
FASTENING THE CUTTING CHAMBER
Slide the hold-down clamps downward you
until they are engaged over the cutting chamber
hatch
Turn the lock bolts clockwise to tighten them
Re set safety Switch Interlock
Set Final torque