Sterlco ST500 Series Central Granulator - Manual (Page 58)

58
SETTINGS AND ADJUSTMENTS
SECTION 4-24
Setting and Adjusting the Rear Chamber Pneumatic Cylinder
The pneumatics, which open the machine, should not operate
until the power is completely disconnected. If you discover
that the pneumatics DO operate while the power is still on,
immediately shut down the machine and call for maintenance
to adjust it.
Make sure no one is near the rear hatch during
operation.
Actuate the cutting chamber cylinder from the
pneumatic console by turning the switch to the
LOWER position. Hold the switch till the hatch stops