Sterlco S-150 Digital Dosing Controller - Manual (Page 43)

Digital Dosing Units 43
Step 4:
• Press and hold until the totalizer appears on the screen.
• The recipe is now active and can be run or edited.
NOTE: The recalled recipe now becomes the active recipe.
4.2 Clearing the Totalizer
• The totalizer displays the total amount of additive dosed since the last time
the totalizer was cleared.
• The totalizer can be cleared by pressing Stop continuously for 5
seconds until the display is reset to “00.00.” The totalizer can be configured
to read throughput in grams or pounds.
• See Appendix A to learn how to change the unit of measure.
4.3 Acknowledging Alarms
• When an alarm occurs, the Alarm symbol flashes red and the dosing
process stops.
• If the Digital Dosing is equipped with an audible alarm or flashing light, it will
also be activated.
• Alarms are acknowledged by pressing .
• The alarm will also initiate an error code.
• See Appendix A for Troubleshooting suggestions for various alarms.
• The alarm condition must be corrected prior to beginning operation again.