Maintenance – Prochem Everest EFI User Manual
Page 33

MAINTENANCE
EVEREST EFI 980197 06/30/04
4-1
SERVICE SCHEDULE
Engine
Daily
Check engine oil level. *** Fill to proper level
Engine
Daily
Check coolant level in overflow bottle
Vacuum Pump
Daily
Spray WD-40 in lubrication cup at front of console for 5
sec.
Water Pump
Daily
Check oil level.** Fill to proper level
Solution Inlet Tube Strainer
Daily
Check strainer for blockage, remove any debris
Vacuum Inlet Filter (In Waste Tank)
Daily
Clean filter, inspect, replace if damaged
Vacuum Hoses
Daily
Wash out with clean water
Automatic Waste Pump
Daily
Inspect and remove any debris or sediment
Chemical Filter
Daily Inspect
daily
Vacuum Pump
Weekly*
Check oil level. Fill to proper level
Water Box Float Valve
Weekly
Check for proper seating and shut-off
Water Pump Inlet Filter
Weekly*
Check for debris and clean
Temperature Balance Orifice
Weekly
Remove, clean and check
Battery
Weekly*
Check for proper fluid level. Fill with distilled water only
Solution Outlet Y-Strainer
Bi-Weekly*
Inspect and remove any debris or blockage
High Pressure Hoses
100 hrs
Inspect for damage or impending damage
Pressure Regulators
100 hrs
Lubricate o-rings
Engine
100 hrs
Change engine oil***
Engine
100 hrs
Change oil filter***
Engine
100 hrs
Check fan belt tightness
Battery
100 hrs*
Clean battery terminals
Float Valve Seal
200 hrs.
Replace seal
Engine
200 hrs
Check radiator hoses and clamp tightness
Fuel Pump
200 hrs
Check hose connections and wire connections
Flow Simulator And Chemical Valves
200 hrs
Inspect and/or adjust packing nuts
Engine
250 hrs
Service air cleaner elements*
Engine
250 hrs
Check spark plugs for carbon deposits and proper gap
Intake & Exhaust Valve Clearances
250hrs/
1500 hrs
Check operating temperature
Cylinder Head Bolts & Manifold Nuts
250 hrs/
2000 hrs
Retighten
Ignition Timing
250 hrs
Inspect
PCV Valve/hoses
750 hrs
Inspect
I.C. Ignition Distributor