NORD Drivesystems BU0050 User Manual
Page 15
1.2 USS - Modules
BU 0050 GB-3111
Subject to technical amendments
15
1.2.2.5
USS Customer Interface
(SK CU1-USS, Option)
In addition to data connections, the USS customer units are also
equipped with conventional digital inputs and outputs.
Via the existing relay contacts, a mechanical motor brake can be
controlled or readiness for operation can be communicated to a
higher level system.
The digital input has a 2.5V switching threshold for the evaluation
of the temperature sensor. The input can, however, also be used
for an emergency stop function.
Connector
Functions
Maximum cross-section
Parameter
X4.1
Output relay
1,5 mm
2
P434 ... P436
X4.2
Digital input
1,5 mm
2
P420
X4.3
Data cables
1,5 mm
2
P503 ... P548
NOTE: All control voltages are based on a common reference potential!
Potentials AGND /0V and GND /0V are internally linked in the device.
The maximum total current 5/15V is 300mA!
X
4
.1
X
4
.2
X
4
.3
01 REL1.1
02 REL1.2
41 VO +5V
40 GND /0V
73 RS485+
74 RS485-
21 DIG IN 1
42 VO +15V
Data cables:
RS485
(
terminal
73-74, RS485 +/-)
Control signal: 2.5 ... 33V
Output relay:
Max. 2.0A
28V DC /230 V AC
Digital input
1 (P420)
Voltage supply: 15V
USS
USS termination resistor
not connected
connected
ON
OF
F