Asante Technologies 6200 - Manual (Page 154)

VLAN Port Attribute Configuration
Page 9-17
Enter Port VID (1 - 4095) >
Enter the VID of the VLAN to which this port is associated and
press
return . If no value is given or if the given value is an
invalid VLAN ID, port tagging is not disabled and the following
message is displayed:
Tagging NOT Disabled, press any key to continue
∆
Note: Port VID and Tagging information are
stored in a Non-Volatile Data Base, so you do
not have to configure them each time the system
starts up.
Map a Port to Multi-
ple VLAN Groups
This option is mainly available for making a port belong to
multiple VLAN Groups. But this option can also be used instead
of the "Set Port VID" option to make a port belong to a VLAN
Group. When used for port-to-multi-VLAN Group mapping, this
option gives a warning message if port tagging is disabled.
To make a port belong to one or more VLAN Groups, press m
in VLAN Port Attribute Configuration Menu. The following
message appears:
Enter VLAN Group #s separated by spaces (0
means ALL) >
If you want to make a port belong to only one VLAN Group,
enter the corresponding VLAN Group number next to the
prompt and press
return . The port is now made a member of
the desired VLAN Group and the screen shows the changed
configuration.
If you want to make a port belong to more than one VLAN
Group, enter the corresponding VLAN Group numbers,
separated by spaces, and press
return . If port tagging is
enabled, then the port is made a member of the desired VLAN
Groups and the changes are shown on the screen. If the value
given is 0, then the port is made a member of all VLAN Groups
in the system.
6216M Book Page 17 Wednesday, January 27, 1999 5:26 PM