Metex 3200U Ultrasonic Flow & Level Monitor - Manual (Page 4)

KEYPAD SYSTEM
The Ultrason has a simple 3-button
calibration system. Operating and
calibration modes are shown on the
16-digit alphanumeric display. The
keypad is used to move around the
menu to calibrate the Ultrason, and to
view operating mode and functions. A
beep is sounded as each key is pressed.
If the keypad is not used for 2 minutes,
the Ultrason will automatically go to
RUN mode (scrolling display). Use the
keypad to explore the Menu and
become familiar with its features.
MENU - FLOW CHART
The following diagram shows part of the Ultrason Menu system. Arrows show the three directions to
leave a box. Pressing a corresponding keypad arrow will move to the next box in the direction shown.
Move the cursor (or underline) under numerals to increase or decrease the number with the
И З keys.
At the bottom of each Menu column is a Store? Yes box. To store the calibration values permanently
(even through power failure), move the cursor under Yes and press the
È or Ç key. If the È key is
pressed with the cursor under Store? no changes will be stored and the system will return to the top of
the Menu column.
AquaMetrix
Ultrason
Page 4