Metex 3200U Ultrasonic Flow & Level Monitor - Manual (Page 37)

Press
È to
Interval and
Æ to the
Sec/Min column. Press
È or Ç to set the logging time interval.
Choose:
30 Sec
10 Sec
5 Sec
2 Sec
1 Sec
30 Min
10 Min
5 Min
2 Min
1 Min
Press
Æ to return to
Interval and press
È to
Reset Log? To erase all existing data in the log press
Æ to
Yes and
È. To keep existing data in the Log press È from
Reset Log? If you have made
changes to the Start Date, Time or Interval, the data logger will automatically start a new “session”. The
Ultrason will display “
xxxxx Hrs/Days Left ”.
From the xxxxx Hrs Left display press
È to
Store? Yes . Press
Æ to
Yes and then
È to save
your Data Logging setup, or press
È from
Store? to cancel changes made above and exit without
storing changes.
From the Data Logging Store? Yes prompt the menu will return to RUN STOP SETUP . Press
Æ to
position the cursor under RUN and press
È to activate the Data Logger to start. The Ultrason will
display SESSION NO. x . Press
È to return to
DATA LOGGING .
Logging "Sessions"
Each time you select STOP in the DATA LOGGING menu, the Data Logger stores the current data in
memory as a " SESSION NO " automatically numbered from " 1 " to " 10 ". If you resume logging by
selecting RUN , the Data Logger will report that a new logging session is started and titled " SESSION
NO xx ". When you download the logger files to your PC using AquaMetrix Logger software, each
Session will open as a separate graph/table titled "AquaMetrix Data Log xx".
Important:
If you
STORE instrument calibration changes under the UNITS/MODE or CALIBRATON menus, STOP
the data logger and select RUN again to start a new logging Session with your new calibration values.
AquaMetrix
Ultrason
Page 37