KANOMAX 3443 Digital Dust Monitor User Manual

Page 35

3. Display Description and operation Procedure

(1) Data Update Interval: The output data is output every one second.
(2) Load Impedance:

1 KΩ or higher

(3) Output Cable:

Please purchase our optional output cable (3442-01).

Method to output measurement data (in case of analog output)

Explanation

Concentration value
(mg/m

or CPM) will be

converted to the output
voltage.

When the reading exceeds the set concentration value during a
measurement, the alarm will be turned ON. And when the reading
becomes lower than the set concentration value, the alarm will be OFF.
This alarm will be activated only during a measurement.
(Even if the alarm is ON during a measurement, it will be OFF once the
measurement finishes.)

When alarm mode setting is OFF, the alarm function is not activated.
Use [▲] [▼] keys to change the mode setting.

After setting the alarm mode, press [SET] key.
The RANGE setting value will be highlighted. Use [▲] [▼] keys to set
the value. After setting, press [SET] key. Then the RANGE setting value
will stop being highlighted.

0 1 2 3 4 sec（Measurement Time)

Voltage

* Use the dedicated output cable (3442-01) sold separately.

mg/m3

CPM

OFF

[▲] key to CPM setting ↓ ↑ [▼] key to mg/m3setting

[▲] key to OFF setting ↓ ↑ [▼] key to CPM setting

10.000

9.999

[▼] key to decrease ↓ ↑ [▲] key to increase