KANOMAX 3443 Digital Dust Monitor - Manual (Page 20)

3. Display Description and operation Procedure
14
You can switch over the indicated value as described below by pressing
[mg/m3] key in real time.
In TWA mode you can perform a measurement based on the settings
referring to H) TWA MODE in 3.4.6 Utility.
Press [START/STOP] key to start a measurement. After a
measurement completes, the measurement result will be displayed.
The remaining measurement time is indicated on the bottom of the
screen and also shown in the bar graph.
You can forcibly finish a measurement by pressing and holding
[START/STOP] key for about two seconds.
In TWA mode you can switch over the indicated value as described
below by pressing [mg/m3] key during and after a measurement.
Switching over measurement value
mg/m3 (Instantaneous Value)
[mg/m3] key ↓
CPM (COUNT)
mg/m3 (Instantaneous Value)
[mg/m3] key ↓
Switching over measurement value
mg/m3 (Instantaneous Value)
[mg/m3] key ↓
mg/m3 (TWA)
mg/m3 (STEL)
mg/m3 (C)
CPM (COUNT)
[mg/m3] key ↓
[mg/m3] key ↓
[mg/m3] key ↓
mg/m3 (Instantaneous Value)
[mg/m3] key ↓
Mg/m3
mg/m3 (Instantaneous Value)
CPM(COUNT) 01min
CPM(COUNT)
mg/m3 (C)
mg/m3 (S)
mg/m3 (T)