beautypg.com

KANOMAX 3443 Digital Dust Monitor User Manual

Page 19

background image

3. Display Description and operation Procedure

13

A) Standard Mode (STD. MODE)

In the Standard Mode select the time from the pre-set measurement time.
The selectable measurement time is 6 sec, 10 sec, 30 sec, 1 min, 2 min, 3
min, 5 min 10 min or TWA (Time Weighted Average) mode.
While the measurement time is highlighted, you can change the time by
using [▲] [▼] keys.




Move the cursor to STD. SET, and then press [SET] key to highlight the
measurement time to configure the setting.
Once a measurement time is selected, press [SET] key.
The measurement time will stop being highlighted.
Use [▲] [▼] keys to move the cursor to “SAVE INFO”, and press [SET]
key to save the setting. Then a measurement screen will be displayed
To go back to a measurement screen before you complete the setting,
press [MENU] key.













<6 sec, 10 sec, 30 sec, 1 min, 2 min, 3 min, 5 min 10 min or TWA mode>

A measurement is performed for the set measurement time.
Press [START/STOP] key to start a measurement. After a measurement
finishes, the measurement result will be displayed. The remaining
measurement time will be indicated at the lower left and also indicated in
the bar graph below the measurement value.
You can stop a measurement before it completes by pressing and holding
[START/STOP] key for about 2 seconds.

Measurement Time Transition

06sec

[▲] Key [▼] Key

10sec

[▲] Key [▼] Key

30sec

[▲] Key [▼] Key

01min

[▲] Key [▼] Key

02min

[▲] Key [▼] Key

03min

[▲] Key [▼] Key

05min

[▲] Key [▼] Key

10min

[▲] Key [▼] Key

06sec

mg/m3 (Instantaneous Value)