KANOMAX 3443 Digital Dust Monitor - Manual (Page 15)

3. Display Description and operation Procedure
9
3. Display Description and Operation Procedure
3.1 Boot Screen
Press [POWER] button to turn ON the instrument. Then the boot screen
will be displayed and start warming up for 10 seconds.
On the screen the version information and remaining time for warming
up will be displayed.
3.2 Initial Screen
After the warm-up, the screen will be displayed as below.
(1) Date & Time
(2) Remaining battery level
(For details, please refer to 2.1 Setting batteries or AC adapter.)
(3) Relative concentration bar(instantaneous value)
(4) Indicated value
(5) Unit
(6) Time graph display while measuring
Once a measurement starts, the bar graph will be updated. When
the measurement finishes, the bar graph will disappear.
In Manual Mode the graph will not be displayed.
(7) Remaining measurement time
Once a measurement starts, the remaining time will be displayed
while the bar graph is being updated.
In Manual Mode the elapsed time will be displayed.
(8) Measurement mode
The selected measurement mode will be displayed.
Standard
Mode: STD. MODE
Free Setting Mode: FRE. MODE
Manual Mode: MANUAL
Calculation Mode: CALC. MODE
[START/STOP] Key: To start a measurement or to halt a measurement while measuring
To stop a measurement in Manual Mode
To end a measurement, press and hold [START/STOP] key for approximately 2
seconds.
[mg/m3] Key: Press this button to convert unit between “mg/m 3 ” and “CPM”.
[MENU] Key: To move to the menu screen. Refer to 3.4 MENU.
(1)
(2)
(3)
(4)
（5）
(6)
(7) (8)