GW Instek GDM-8246 Programming Manual - Manual (Page 9)

GDM-8246 MULTIMETER
PROGRAMMER MANUAL
⎯ 16 ⎯
:CONFigure:SFRequency Sets frequency function.
:CONFigure:RESistance Sets resistance function and range.
:CONFigure:VOLTage:AC Sets AC voltage function and range.
:CONFigure:VOLTage:DC Sets DC voltage function and range.
:CONFigure:VOLTage:ACDC Sets AC+DC voltage function and
range.
:CONFigure:VOLTage:DCAC Sets Ripple voltage function and
range.
:READ? Returns the value displayed on the
primary and secondary display
:VALue? Returns the value displayed on the
primary display.
:SVALue? Returns the value displayed on the
secondary display.
GDM-8246 MULTIMETER
PROGRAMMER MANUAL
⎯ 17 ⎯
z Calculation Commands
:CALCulation: LIMit:STATe? Returns Compare mode on or off.
:CALCulation: LIMit:STATe Sets Compare mode on or off.
:CALCulation: LIMit:LOWer?
Returns the value of the lower
limit.
:CALCulation: LIMit:LOWer Sets the value of the lower limit.
:CALCulation: LIMit:UPPer?
Returns the value of the upper
limit.
:CALCulation: LIMit:UPPer Sets the value of the upper limit.
:CALCulation: LIMit:FAIL? Returns the limit result.
:CALCulation:MAXimum?
Returns the MAX mode on or
off.
:CALCulation:MAXimum Sets the MAX mode on or off.
:CALCulation:MINimum? Returns the MIN mode on or off.
:CALCulation:MINimum Sets the MIN mode on or off.
:CALCulation: RELation: STATe Sets REL mode on or off.
:CALCulation:RELation: STATe? Returns REL mode on or off.
:CALCulation:RELation:DATa?
Returns the reference value of
the REL mode.
:CALCulation:RELation:DATa
Sets the reference value of the
REL mode.