GW Instek GDM-8246 Programming Manual - Manual (Page 19)

GDM-8246 MULTIMETER
PROGRAMMER MANUAL
⎯ 36 ⎯
:CALCulation:LIMit:LOWer?
:CALCulation:LIMit:LOWer
Examples:
:CALCulation:LIMit:LOWer? might return +1.0000 in the DC voltage
function.
:CALCulation:LIMit:LOWer 1.0000 sets 1.0000 DC voltage at the lower
limit in the DC voltage function.
:CALCulation:LIMit:UPPer
Function:
Returns or sets the value of the upper limit in the compare mode.
Syntax:
:CALCulation:LIMit:UPPer?
:CALCulation:LIMit:UPPer
Examples:
:CALCulation:LIMit:UPPer? might return +1.0000 in the DC voltage
function.
:CALCulation:LIMit:UPPer 1.0000 sets 1.0000 DC voltage at the upper
limit in the DC voltage function.
:CALCulation:LIMit:FAIL?
Function:
Returns limit result.
Syntax:
GDM-8246 MULTIMETER
PROGRAMMER MANUAL
⎯ 37 ⎯
:CALCulation:LIMit:FAIL?
Examples:
0(low)/1(pass)/2(high)
:CALCulation:LIMit:FAIL? might return 1 means the reading is pass.
:CALCulation:MAXimum
Function:
Returns or sets the MAX mode on or off.
Syntax:
:CALCulation:MAXimum?
:CALCulation:MAXimum
can be o(off) or 1(on).
Examples:
:CALCulation:MAXimum? might return 1 in the MAX mode.
:CALCulation:MAXimum 1 sets the MAX mode.
:CALCulation:MINimum
Function:
Returns or sets the MIN mode on or off.
Syntax:
:CALCulation:MINimum?
:CALCulation:MINimum