GW Instek GDM-8246 Programming Manual - Manual (Page 15)

GDM-8246 MULTIMETER
PROGRAMMER MANUAL
⎯ 28 ⎯
DC Current DCA
AC Current ACA
AC+DC Current AC+DCA
ACA + Frequency Hz+ACA
Resistance OHM
Capacitance CAPACITANCE
Diode DIODE
Continuity CONT
Ripple RIPPLE
:CONFigure:CAPacitance
Function:
Set capacitance function and the range.
Syntax:
:CONFigure:CAPacitance
Examples:
:CONFigure:CAPacitance 0 sets to capacitance function and auto-range.
:CONFigure:CAPacitance 30 sets to capacitance function and 50nF
range.
Please refer to the unit for every range shown as Table 6-1.
:CONFigure:CONTinuity
Function:
Set the continuity function
Syntax:
:CONFigure:CONTinity
GDM-8246 MULTIMETER
PROGRAMMER MANUAL
⎯ 29 ⎯
Examples:
:CONFigure:CONTinity sets the continuity function.
Please refer to the Table 6-1.
:CONFigure:CURRent:DC 2>
Function:
Set the DC current function and range.
Syntax:
:CONFigure:CURRent:DC
Examples:
:CONFigure:CURRent:DC 0 sets the DC current function and
auto-range.
:CONFigure:CURRent:DC 1.5 sets the DC current function and
5mA
range.
Please refer to the unit for every range shown as Table 6-1.
:CONFigure:CURRent:AC 2>
Function:
Set the AC current function and range.
Syntax:
:CONFigure:CURRent:AC
Examples:
:CONFigure:CURRent:AC 0 sets the AC current function and
auto-range.
:CONFigure:CURRent:AC 1.5 sets the AC current function and
5mA
range.