Fire-Lite PS Tools MS-9600 - Manual (Page 44)

36 636 Pt Addr.Panel
PS-Tools 04/2010
Configuring Fire Panels
Configuring ANN BUS
ANN-BUS is a communication terminal in the fire panel over which different ANN devices can be
installed to communicate with the FACP. The ANN devices such as ANN-S/PG Printer Interface
module, ANN-I/O LED Driver Module, ANN-LED Annunciator Module, ANN-RLY Relay module,
and other types can be installed in the fire alarm system. You can configure the ANN-BUS, when any
ANN devices are installed.
Figure 5-7 Configuring ANN Bus Global Options
ANN Bus
To configure the ANN Bus Settings
1. Click Next at the lower-right corner of the Optional Modules pane to view the ANN Bus
settings pane or click ANN Bus Settings > Global Options in the left pane.
2. Click Yes to enable the ANN BUS. You must enable the ANN BUS if any modules are
connected to the ANN BUS terminal.
The following are the compatible devices that you can connect to the FACP ANN-BUS
communication circuit.
• ANN-80 LCD Annunciator
• ANN-S/PG Serial/Parallel Printer Interface Module
• ANN-I/O LED Driver Module
• ANN-LED Annunciator Module (alarm, trouble, supervisory LEDs)
• ANN-RLED Annunciator Module (red alarm LEDs only)
• ANN-RLY Relay Module to the ANN BUS
• ANN-AUDIO