Fire-Lite PS Tools MS-9600 - Manual (Page 34)

26 636 Pt Addr.Panel
PS-Tools 04/2010
Configuring Fire Panels
Figure 5-2 Configuring Primary Central Station
Primary Central Station screen provides information on the primary central station programming
which includes:
• Phone Number
• Communication Format
• Account Code
• Test Time Interval
• Test Start Time
• Event Codes
To configure the primary central station
1. Type the Phone Number of the primary central station. You can type a maximum of 20
characters with valid entries being 0 to 9 and A to E.
2. Select the Communication Format of the reports sent to the primary control station. The
primary event codes are displayed based on the communication format used.
Note If the communication format changes, the event codes also change. The
communication format is determined by the type of receiver at the primary central
station, to which the optional modules transmit reports.
3. Type the Account Code for the panel. Each panel has a unique account code depending on the
primary central station and the communication format being used.
4. Select the desired Test Time Interval (6, 8, 12 or 24 hours) to send the test report to the
primary central station.
5. Type the Test Start Time to program the time at which the optional modules run the test. Type
a four digit number using military time (0000 refers to 12:00AM and 2359 refers to 11:59PM).
6. Under Phone Line 1, select the type of the phone line. The available options are Touch Tone,
Rotary 67/33, and Rotary 62/38.
7. Click Save to Database to save the configuration.