Fire-Lite MS-25E Addressable Fire Control Panel - Manual (Page 103)

Cut Along the
Dotted
Line
Model MS-25/MS-25C/MS-25E Basic Operating Instructions
These Instructions must be framed and displayed next to the MS-25 panel in accordance with NFPA 72
fire code for Local Protected Fire Alarm Systems. Test the system in accordance to NFPA 72. Refer to
Installation Manual P/N 53688 for more information regarding this control panel.
Operation Task to Perform
Silence Alarms and
Troubles
Press . Silence LED will light.
Reset Alarms
Press .
Acknowledge Alarms and
Troubles
Press .
View Alarms Zones that are in alarm will have their alarm LED on. To view all points in
alarm press Alarm ID followed by
or button to view the SLC ID for
each point.
View Supervisories Zones that are in supervisory will have their supervisory LED on. To view all
points in supervisory press Supervs ID followed by
or button to view
the SLC ID for each point.
View Troubles Zones that are in trouble will have their trouble LED on. To view all points in
trouble press Trouble ID followed by
or button to view the SLC ID for
each point.
Conduct a Fire Drill
1. Press to start Fire Drill.
2. Press to end Fire Drill.
Dialer Test
Press and key at same time.
Lamp Test
Press and key at same time.
Enable / Disable a Zone or
Circuit Press the corresponding disable key. Press it again to enable the zone or
circuit. For ULC, you must enter the Installation code after pressing Zone
Enable/Disable.
Remote Connection
Feature (ULC Installations
Only)
Press the and at the same time to disconnect the communication
paths to the Central Station and/or remote station. The PZT on the panel will
sound and the General Trouble LED will be flashing. This will remain active
until you press the Walk test and Acknowledge buttons again.
For Service call:
P/N 53697 Rev. A ECN 10-157
1