DeFelsko PosiTector 100 v.4.0 - Manual (Page 20)

Page 20 100 Series
Select an Existing Application
Use the
↓ ↑
buttons located below the list box to move the highlighter to your
choice. Notice that details on the currently highlighted application appear
immediately in the left side of the LCD. Only applications created for the
currently connected probe are visible. Select the
Setup q
q Application
Setup q
q Select an App menu item. Press the OK button to complete the
selection process. The application is now open to accept changes or stored
readings (memory option only). The name of the current application is listed in
the status bar at the top of the LCD. Memory mode must be turned off before
selecting a new application.
Edit Application Settings
Use the
↓
button located below the application details to move the highlighter to
the setting you wish to change. Some settings cannot be changed once readings
have been recorded in that application.
Create a New Application
New applications are created by simply making a copy of an existing application. First,
select an existing application as described above. Then choose
Create a new App. A
new application name with a sequentially higher number will appear in the application list
box. The original application, however, remains as the current, open application.
For example: Four applications exist called App1, App3, App4 & App5. App2 was
previously deleted. App4 is current. When the
Create a new App menu choice is
selected, App6 will be created with App4’s settings and App4 will remain current.
A new application is automatically created when a new probe is attached.
Delete an Existing Application
Select the
Setup q
q Application Setup q q Delete an App menu item.
Use the
↓ ↑
buttons located below the list box to move the highlighter to your
choice. Notice that details on the currently highlighted application appear
immediately in the left side of the LCD. Also note that all applications for all
probes are displayed.
Press the
OK button to delete the highlighted application. All stored
measurements, names and settings are deleted and the application name is
removed from the list box. Once deleted this information cannot be recovered.
To exit the delete routine without making any deletion, select
from the
application list box and then press the
OK button.