DeFelsko PosiTector 6000 v.4.0 User Manual
Page 27

27
When temperature compensation has
been made or the probe has stabilized,
the beeping will stop and a measurement
will be displayed.
Quick Release Adapter
The F0S and N0S Microprobes are
supplied with a quick release adapter to
convert them to constant pressure probes
for alignment on small, flat or curved
parts.
The adapter is held in place by a spring
located on the microprobe cable. If the
sleeve is not required, simply pull it off the
probe. To re-attach it, slide it over the
microprobe and screw it into the spring.
NOTE:
Due to their exceptional
measuring sensitivity, it is necessary to
fixture the N0S, N45S or N90S probes
when measuring.
Maintenance
The 6000 requires no regular
maintenance other than battery
replacement. Paint, dirt and other marks
on the gage housing may be removed
with a solvent such as acetone.
Certification
All Gages are shipped with a Certificate of
Calibration. Some organizations have a
compliance requirement to re-certify
Gages periodically. This can be done by
measuring traceable Standards (available
from your dealer) or by returning the
Gage to an authorized dealer to be re-
certified.