Star Water Systems EL10S - Manual (Page 17)

17
IL1129
8
8. All piping from the well to the pump should
slope slightly upward with no sagging. Support
suction pipe between water source and pump.
Unions in the suction line near the pump and
well will aid in servicing. Be sure to leave
enough room so that wrenches can be used
easily.
( Fig. 8)
NOTE: Look for leaks or a milky color in the
discharged water, which indicates an air leak.
Re-prime if necessary, following steps 1 through
6 above. Reset breaker at the breaker box. All
connections must be water and air tight in order
for pump to operate.
questions? Call 1-800-742-5044 Monday -
Friday 7:30 am - 5:00 pm EST.
IMPORTANT: If the pump fails to prime within five minutes:
Turn power off at the breaker box and check all pipe connections for leaks. All connections must be
water and air tight in order for pump to operate.
PUMP PRIMING & STARTUP (CONTINUED)