Star Water Systems 3SDHL - Manual

NOTICE TO INSTALLER: Instructions must remain with installation.
FW1286
0413
SuperSedeS
0611
S2n1
PREASSEMBLED SUMP PUMP SYSTEM
WITH BATTERY BACKUP
12V DC BATTERY BACKUP SYSTEM WITH 120V AC POWERED SUMP PUMP MODEL 3SDHL
PRE-INSTALLATION CHECKLIST
Product information presented
here reflects conditions at time
of publication. Consult factory
regarding discrepancies or
inconsistencies.
S
TAR
®
95 North Oak Street • Kendallville, IN 46755
800-742-5044
visit our web site:
starwatersystems.com
1. Inspect your pump. Occasionally, products are damaged during shipment. If the unit or any of the parts are
damaged, contact your dealer before using.
2. read all the installation instructions regarding installing and start up. retain for future reference.
1. WARNING: Make certain that the receptacle
is within the reach of the pump’s power supply
cord. dO NOT uSe AN eXTeNSION COrd.
extension cords that are too long or too light do not
deliver sufficient voltage to the pump motor. But,
more important, they could present a safety hazard
if the insulation were to become damaged or the
connection end were to fall into the sump.
2. WARNING: Make sure the pump electrical
supply circuit is equipped with fuses or circuit
breakers of proper capacity. A separate branch
circuit is recommended, sized according to the
“National electrical Code” for the current shown on
the pump nameplate.
3. WARNING: Testing for ground. As a safety
measure, each electrical outlet should be checked
for ground using an underwriters Laboratory Listed
circuit analyzer which will indicate if the power,
neutral and ground wires are correctly connected to
your outlet. If they are not, call a qualified licensed
electrician.
4. WARNING: For Added Safety. pumping and
other equipment with a 3-prong grounded plug must
be connected to a 3-prong grounded receptacle. For
added safety the receptacle may be protected with a
ground-fault circuit interrupter. When a pump needs
to be connected in a watertight junction box, the plug
can be removed and spliced to the supply cable with
proper grounding. For added safety this circuit may
be protected by a ground-fault circuit interrupter. The
complete installation must comply with the National
electrical Code and all applicable local codes and
ordinances.
5. WARNING: FOr YOur prOTeCTION,
ALWAYS dISCONNeCT puMp FrOM ITS pOWer
SOurCe BeFOre HANdLING. Single phase
pumps are supplied with a 3-prong grounded plug to
help protect you against the possibility of electrical
shock. dO NOT uNder ANY CIrCuMSTANCeS
reMOVe THe GrOuNd pIN. The 3-prong plug
must be inserted into a mating 3-prong grounded
receptacle. If the installation does not have such a
receptacle, it must be changed to the proper type,
wired and grounded in accordance with the National
electrical Code and all applicable local codes and
ordinances. pumps must be installed in accordance
with the National electrical Code and all applicable
local codes and ordinances. pumps are not to be
installed in locations classified as hazardous in
accordance with National electrical Code, ANSI/
NFpA 70.
6. WARNING: “risk of electrical shock” do not
remove power supply cord and strain relief or connect
conduit directly to the pump.
7. WARNING: Installation and servicing of
electrical circuits and hardware should be performed
by a qualified licensed electrician.
8. WARNING: pump installation and servicing
should be performed by a qualified person.
9. WARNING: risk of electric shock - These
pumps have not been investigated for use in
swimming pool and marine areas.
10. WARNING: According to the state of California
(prop 65), this product contains chemicals known
to the state of California to cause cancer and birth
defects or other reproductive harm.