Star Water Systems EL10S - Manual (Page 16)

16
PUMP PRIMING & STARTUP (CONTINUED)
20
20 20
20
IL1339
Breaker Box
7
7. Turn on breaker to start pump. ( Fig. 7)
IMPORTANT: If the pump hums instead of
pumping or turns off repeatedly, shut pump off
immediately.
Check voltage. Make sure your incoming voltage
matches the pump wiring voltage. See wiring
guide in the instructions.
IL1353
5
5. Thread in priming plug and then open optional
ball valve if installed by turning handle to line
up with the pipe. (Fig. 5)
IL1352
Water Level in
Pump Cavity
4
4. Check to be sure water in pump cavity stays
constant. If water level goes down, it could
indicate a leak in the foot valve, check valve or
suction pipe. (Fig. 4)
IL1768
Check Valve
Well Point
6
6. PRIMING NOTE: Several priming attempts
may be necessary, depending on the length
of suction pipe and location of check valve if a
well point is being used.