Spectra Precision Survey Pro v5.3 - Manual (Page 101)

93
Memo for GNSS Users
Assuming the following:
• A receiver profile has been created previously so you can use your RTK rover
in a network.
• If you are using a “network rover”, a network has also been defined
previously for the purpose of receiving corrections from an IP server. (No
network profile needs to be created if you are using a “rover” receiving
corrections from a base via radio.)
• A new job file needs to be created in which a known coordinate system and
a geoid are used.
Then proceed as indicated below:
• Turn on your receiver.
• Start Survey Pro on the data collector.
• Create a job in which you select the coordinate system and geoid used.
• Tap the instrument icon and select Switch to GNSS.
• Go to Survey >Start Survey.
• Select the receiver profile prepared earlier for your rover.
• Select the network used (skip this step if you are using a “rover”, and not
a “network rover”).
• Tap Connect.
• Wait until the rover receives data from the base.
• Confirm/change the point where the base is located.
• Set acceptance criteria for all your measurements.
• Make sure the receiver continuously delivers a “Fixed” position solution.
(You may also go to Survey > GNSS Status to check the GNSS reception
status and then come back to Survey > Data Collection.)
• Start collecting your data (points, offset points, lines). Data may be
collected using one epoch of data (always the case when collecting data
along a line), or by averaging the position through a static occupation on
each point.
• When finished, select End Survey on the Home screen.