Seed Hawk AIRCART 2014 - Manual (Page 30)

SEED HAWK ® 2014 AIRCART OPERATOR’S MANUAL SEED HAWK ® 2014 AIRCART OPERATOR’S MANUAL 52
This menu allows the user to set the units of measure, language, implement
width, the volume of the alarm, screen settings (backlight and contrast), and the
master switch mode. To access the Global Settings from the run screen press
any soft key to bring up the soft key menu and press
Setup. Navigate the high-
light bar to the “Global Settings” selection and press Enter.
At this screen you can review the basic system setup and make changes as
necessary. To make changes, navigate the highlight box to the item you wish to
adjust and press
Enter. A drop down box will appear and display the available
options. Select the desired setting and press Enter.
7.4.2 Global Settings
1. Units: Available choices are Metric,
Imperial, and US Imperial. Navigate to
the desired selection and press
Enter.
2. Language: Available choices are
English and Russian. Navigate to the
desired language selection and press
Enter.
53
4. Volume: Sets the alarm volume
level. Navigate to this selection and
press the
Selector Knob to high-
light the item. Rotate to increase or
decrease the alarm volume and press
the
Selector Knob or Enter to set
the new alarm volume setting.
5. Backlight: Sets the display back-
light level. Navigate to this selection
and press the Selector Knob to high-
light the item. Rotate to increase or
decrease the backlight and press the
Selector Knob or Enter to set the
new backlight setting.
3. Width: This is the width of the
implement, Navigate to this item and
press
Enter. A drop down keypad
will appear allowing the operator to
enter the implement width in the
form XX.X feet or meters depending
on the units selected. Navigate to the
individual numbers and press the
Tog-
gle knob to accept.
When the total number is entered
press the
Enter key to save the new
width value.
NOTE: This is the only
instance when the Selector
Knob and the Enter key
perform separate functions.
6. Contrast: Sets the display contrast.
N
avigate to this selection and press
the Selector Knob to highlight the
item. Rotate to increase or decrease
the contrast and press the
Selector
Knob or Enter to set the new con-
trast setting.