Seed Hawk AIRCART 2014 - Manual (Page 20)

SEED HAWK ® 2014 AIRCART OPERATOR’S MANUAL SEED HAWK ® 2014 AIRCART OPERATOR’S MANUAL 32
4.4.4 Conveyor Transport Position
2. Arrange the conveyor so that
the upper rest is positioned on the
conveyor saddle at the front of the
aircart. 3. Raise the locking mechanism at the
rear of the aircart. The handle can
be unlocked and swung towards the
aircart for transport
4. Ensure to place pin back into
locking mechanism so that it cannot
disengage during transportation.
6. Secure outer arm locking mecha-
nism. Again ensure to replace pin so
that lock does not disengage during
transportation.
1. Latch down the conveyor hopper then fold it up on top of the conveyor
tube. Be sure to secure it with the tie down strap supplied.
5. Push conveyor diverter valve back
to the fan position. Move hydraulics
in both directions to relieve pressure.
This relieves the tilt cylinder so that it
is not applying unnecessary force on
the support arms.
NOTE: Fill conveyor should
always be secured for
transport, no matter how
short the distance. Clean out
conveyor prior to transport
or storage.
33
4.5 Bag Lift
If equipped, the optional bag lift can be used for transporting bagged agricultural
product from the ground to the top of the air cart. The bag lift has a maximum
capacity of 550 lbs. or ten bags of canola (50 lb. bags).
The bag lift runs off the same hydraulic circuit as the auger or conveyor. To
operate the bag lift the diverter valve must be switched to the
auger or con-
veyor setting. After loading the bag lift use the valve located at the front of the
cart to operate the hydraulic cylinder.
Raise the bag lift to the uppermost position to unload from the catwalk. The
bag lift remains in the uppermost position for transport and storage.
WARNING! Do not transport people using the bag lift,
serious injury may occur.