Seed Hawk AIRCART 2014 - Manual (Page 10)

SEED HAWK ® 2014 AIRCART OPERATOR’S MANUAL SEED HAWK ® 2014 AIRCART OPERATOR’S MANUAL 12
2.9.2 Applied Safety Signs
CAUTION!
READ OPERATOR’S
MANUAL before
operating machine. Heed
all instructions.
DANGER!
MOVING PART
HAZARD.
Rotating Fan blades. DO
NOT service or make
adjustments without first:
•Stopping power source.
•Ensuring bystanders are
at least 100 ft (30 m) away
from machine.
1. Read Operator’s Manual before using machine.
2. Stop tractor engine, lower machine to the ground, place all controls in
neutral, set park brake, remove ignition key and wait for all moving parts
to stop before servicing, adjusting, repairing, unplugging or fitting.
3. Install and secure all guards before starting.
4. Keep hands, feet hair and clothing away from moving parts.
5. Do not allow riders.
6. Keep all hydraulic lines, fittings and couplers tight and free of leaks
before using.
7. Clean reflectors, SMV and lights before transporting.
8. Install safety locks before transporting or working beneath components.
9. Add extra lights and use pilot vehicle when transporting during times of
limited visibilty.
10. Use hazard flashers in tractor when transporting.
11. Install safety chain when attaching to tractor.
12. Keep away from overhead electrical lines. Electrocution can occur
without direct contact.
13. Review safety instructions with all operators annually.
4
SH 400
DANGER!
ENTANGLEMENT
HAZARD.
Keep hands, feet and
clothing away from auger
intake.
DANGER
To Prevent Serious Injury Or Death:
Keep hands, feet and clothing away
from auger intake.
103
13
2.9.3 Safety Sign Information
Safety Sign Legibility: All safety signs applied to the implement must be
visible and legible. Keep dust and dirt cleared from safety signs and ensure that
visibility is not obscured.
Safety Sign Replacement: Replacement safety signs may be ordered through
your dealer or distributor. Contact Seed Hawk Inc. if unable to obtain replace-
ment safety signs from a dealer or distributor.
Damaged or Deteriorated Safety Signs: Remove and replace any safety
signs that have either been damaged or show signs of deterioration.
Safety Signs on Replacement Parts: Ensure that parts or components that
are replaced on the implement that had a safety sign attached originally include
a safety sign.
Affixing Safety Signs to Implement
1. Ensure proper position and orientation before installing.
2. Ensure installation area is clean and dry.
3. Ensure ambient temperature is above 10˚C (50˚F).
4. Remove backing material to expose label adhesive.
5. Place one edge of label to machine surface.
6. Slowly press the label onto the surface.
7. Ensure no air pockets become under surface of label.