Seed Hawk AIRCART 2014 - Manual (Page 24)

SEED HAWK ® 2014 AIRCART OPERATOR’S MANUAL SEED HAWK ® 2014 AIRCART OPERATOR’S MANUAL 40
NOTE: Failure to remove
product prior to storage will
greatly increase the rate of
corrosion in the tanks and
meter.
Prior to storage remove all product from tanks, meters, and fill auger (or
conveyor). Also, ensure that the meters are thoroughly vacuumed or washed.
If the aircart is washed be sure to dry the system out afterwards by
opening the lids and running the fans for 30 minutes. This will prevent damage
occurring from ice buildup, and prevent product sticking to wet components
which creates blockages.
When stored outside tightly cover the fans to seal water out of the airstreams.
The service life of the aircart seals can be extended by unlatching the lids and
loosening the thumb nuts on the cleanout doors.
5.2 Storage
41
The Loup III and Seed Hawk Viper Pro™ monitor are capable of displaying:
The monitors will alert the operator if it detects any of the following condi-
tions:
These settings, as well as the Field and Total Acres are stored in non-volatile
memory. This means that the information is retained even when power is dis-
connected.
The following two sections of this Manual will familiarize you with installation,
calibration, operation and technical information. All aspects are detailed but may
not be applicable to your particular system configuration.
For further information on the operation of the Seed Hawk Viper Pro™ Moni-
tor, refer to the Raven – Seed Hawk Viper Pro™ manual.
• Ground Speed and Acres
• Fan Speeds
• Meter Speeds
• Meter Application Rates
• Hopper Levels
• Low Meter Speed
• Low Bin Levels
• Loss of Tractor Ground Speed
• Low or High Fan Speed
6.0 Air Drill Monitors
• Liquid Flow Meter
• Hydraulic Pressure
• Field Area
• Total Area