Creating standard module selection – Seca 515 User Manual
Page 62

62 •
Creating standard module selection
In order to create an in-house standard module selection, proceed as
follows:
1. Press the
change menu
button.
The secondary menu is displayed.
2. Press the
settings
button.
The
user
menu appears.
3. Press the drop-down menu.
The drop-down menu is opened.
4. Press the
standard module selection
menu element.
The current module selection is displayed.
Factory setting: All modules selected (exception:
Raw data for
impedance
).
NOTE:
• Activating the
Raw data for impedance
module increases the
duration of the BIA measurement. Activate the
Raw data for
impedance
module if you wish to use the measured results for
scientific studies. You can then evaluate raw data for impedance
in the PC software
seca 115
for up to 18 frequencies.
• If you deactivate the
Energy
evaluation module, there is no
request for the Physical Activity Level (PAL) following a BIA
measurement.
5. Press all modules that you wish to deactivate.
The checkmark in the checkbox is no longer displayed.
NOTE:
Press on the module again to reactivate it.
6. Press the
apply
button.
The module selection is saved and available following the next
bioelectric impedance analysis.
NOTE:
To exit the dialog window without saving, press the
cancel
button
or the most recently active tab (red, here
bia
). The most recently
active tab is active again.