beautypg.com

3 performing bioelectric impedance analysis (bia), Switching on the device, Determining the weight and height – Seca 515 User Manual

Page 31: Checking the module selection, 3 performing bioelectric impedance, Analysis (bia)

background image

Operation • 31

English

7.3

Performing bioelectric impedance analysis (BIA)

Switching on the device

1. Ensure that the device has no load.

2. Press the ON/OFF button.

The start screen appears.
The

weight/height

tab is active.

Determining the weight and height

♦ Determine the weight and height as described in section „Determining

the weight and height“ from page 27.

Checking the module selection

1. Activate the

bia

tab.

The bioelectric impedance analysis is available when the message
“Self-test running” is no longer displayed.

The

module selection

dialog window appears. All modules are

activated in the factory (except raw data for impedance).

NOTE:
If the module selection does not appear, the function “Show the
module selection at the start of the measurement procedure” is
deactivated in the

settings

menu. You can reactivate this function

or check the module selection directly in the

settings

menu (see

“Configuring device” on page 61).

2. Check the module selection.

3. Deactivate modules for which no measurements are to be

performed.

NOTE:
• If you activate the

Raw data for impedance

module, the duration of

the BIA measurement is extended. Activate the

Raw data for

impedance

module if you wish to use the measured results for

scientific studies. The impedance data for up to 19 frequencies
are available in the

analysis

tab.

• If you deactivate the

Energy

evaluation module, there is no

request for the Physical Activity Level (PAL) following a BIA
measurement.

4. Press the

continue

button.

This manual is related to the following products: