Seca 515 - Manual (Page 61)

Configuring device • 61
English
9. CONFIGURING DEVICE
9.1 Adapting standard module selection for BIA
The standard module selection determines which evaluation modules are
considered during a BIA.
The device is factory set, so that when activating the bia tab, the standard
module selection dialog window appears and all evaluation modules are
activated. This way, the module selection can be verified before each
measurement and, if necessary, adapted for the individual measurement.
The device can be configured in such a way that the standard module
selection dialog window does not appear if the bia tab is activated.
Furthermore, an in-house standard module selection can be created.
Showing/hiding standard module
selection
In order to determine whether or not the standard module selection dialog
window is displayed before each BIA, proceed as follows:
1. Press the change menu button.
The secondary menu is displayed.
2. Press the settings button.
The user menu appears.
The current setting is displayed (button appears gray = pressed).
3. Enter the desired setting.
– on : Standard module selection is active. It is displayed before
every bioelectric impedance analysis and can be adapted for the
corresponding measurement.
– off : Standard module selection is active but is not displayed
before the bioelectric impedance analysis. Adaptions to the
standard module selection are only possible in the
settings menu.
4. Press the apply button.
The module selection is saved and available following the next
bioelectric impedance analysis.