Seca 515 - Manual (Page 20)

20 •
6.4 Configuring device
Sections 6.5 to 6.7 show the data transmission options provided by the
device. Your administrator or hospital technician decides which data
connection types are set up for your device. Additional configuration
options can be found in the administrator manual on the supplied DVD
“User Documentation”. If you have any requests for changes, please
contact your administrator.
ATTENTION!
Data loss
The improper installation of or improper changes to the installation
can cause data loss and, as a result, misdiagnoses.
− Make sure installation or changes to installation are carried out by
an experienced PC administrator or hospital technician.
6.5 Operating the device in a PC network
The device does not have “on-board” patient and user management. If
you wish to manage electronic patient files and user accounts, the device
must be connected to a PC on which the PC software
seca 115 is installed.
You have the following possibilities:
• Network connection via seca wireless network or Ethernet
• Indirect connection via USB memory stick
Network connection via Ethernet or
seca wireless network
If the device is connected via seca wireless network or Ethernet to a PC on
which the PC software
seca 115 is installed, you can directly access
patient files on the PC software and directly transmit newly created patient
files to the PC software.
NOTE:
• Information on creating and saving patient data can be found in
section „Assigning patient“ from page 35.
• Observe the instructions for use for doctors and assistants for the
PC software seca 115 . If you have any queries regarding data
connections, contact your administrator.
seca 115 seca 115