LT Security LTD7708 - Manual (Page 29)

29
29 INSTRUCTION MANUAL
5） Click CLOSE in the confirmation window. In the system prompt, click OK. The
system will restart.
PARAMETER EXPORT：Copy the system settings of the device to an empty USB flash
drive.
PARAMETER IMPORT：Import system settings from another device.
17 PTZ
Use the PTZ Setup menu to configure settings for a connected PTZ camera (not
included).
NOTE: Consult the instruction manual of your PTZ camera for complete information about
your camera, including protocol and baud rate.
Figure 2.4.2.17 PTZ setup
To configure a PTZ camera:
1) Connect a PTZ camera to the BNC and 485A (TX, +) and 485B (RX, -) ports and
power outlet. For more details on connecting a PTZ camera.
2) Under PROTOCOL, select PELCO-D or PELCO-P for the selected channel.
Click NEXT PAGE for additional channels (8-channel models only).
3) Under BAUD RATE, select 1200, 2400, 4800, or 9600.
4) Under DATA BIT select 5, 6, 7, or 8.
5) Under STOP BIT, select 1 or 2.
6) Under VERIFY, select ODD, EVEN, MARK, SPACE, or NONE.
7) Under ADDRESS, enter an address from 001~255 using the Virtual Keyboard.
Refer to your PTZ camera`s instruction manual for further details.
8) Click APPLY. Click CLOSE in the confirmation window.
9） Click EXIT in all menus until all windows are closed.