Hired-Hand HH Software: Farm Manager - Manual (Page 13)

Part No. 4801-5049 Rev 8/05 Farm Manager Page: 13
Name - The Name of the person or pager being called.
Number - The telephone number to be called in case of an alarm. Up to 16 digits can be entered
in this field. Dashes may be included for clarity. A comma between any digit will cause a short
delay in dialing. This is useful when calling out from a PBX that requires a 9 to be dialed to
access an outside line. If long distance calls are desired, be sure to include an access code, usually
a 1. NOTE: At least one telephone number is required for the Remote Alarm option to work
properly.
Type - This can be Voice or Pager. If pager is set, a message can be forwarded to the pager.
NOTE: A voice capable modem must be installed in the Farm Manager computer.
Message - The message delivered to a pager. Verify the capabilities of the pager provider to
ensure the complete message can be received. Note: This must be a numeric entry.
Remove Entry -First select an entry in the Contact List and click the Remove Entry button. The entry is
permanently deleted from the List.
13.5 When an Alarm Occurs
When an alarm occurs, Farm Manager displays the following screen
and reports alarms as configured. The Farm Manager Alarm screen
shows the Network address, the House name and the Error Code as
reported by the controller or generated by Manager. If available from
the controller, the setup number is also shown as well as a description
of the error. The alarm can be silenced from this screen by clicking
on the Silence button. This action also closes this screen.
If the telephone call generated by the alarm is a pager call, the
message as described in the Contact List is sent to the Pager. If the
telephone call is a voice call, the parameters of the error are reported
by recorded voice to the called party. At the end of the recorded
message, the called party has three options that can be sent using the
telephone keypad. The following codes can be sent to Manager:
KeyPad Result
1 Silence the Alarm.
Star (*) Repeat the voice Message.
Pound (#) Terminate the call.
13.6 Report Setup
With the Report Setup Option, Farm Manager can send scheduled reports
of gathered data to designated recipients.
Sender Information – Enter the
administrative information about your
farm in this section.
Reports –
Add Report - Used to schedule a
new Fax recipient.
Edit Report - Used to modify an
existing recipient.
Remove Report - Used to delete a
Fax recipient.
Report Recipient Setup Option –