Brocade FICON Administrator’s Guide (Supporting Fabric OS v7.3.0) - Manual (Page 107)

Switch configuration example and commands (Continued) TABLE 13
Feature Relevant Commands
If you are enabling FMS (CUP), disable all ports assigned address
0xFE and 0xFF. portdisable
Enable FMS if FICON CUP will be used.
NOTE
High-integrity fabric requirements must be met and HIF mode
enabled to enable FMS mode.
ficoncupset fmsmode enable
ficoncupshow fmsmode
Set the default zone for no access. defZone --noaccess
cfgsave
defZone --show
Configure zones. This is much easier with Brocade Network
Advisor or Web Tools. Typically, scripts are used when using
Fabric OS commands. cfgclear
cfgcreate
cfgdelete
cfgdisable
cfgenable
cfgremove
cfgsave
cfgshow
Clear all port statistics and trace information. supportsave -R
errclear
statsclear
portlogclear
diagclearerror -all
tracedump -c
slotstatsclear
errclear
ficonclear rlir
Turn on FICON logging. supportshowcfgenable ficon
Basic Switch Configuration
FICON Administrator's Guide 105
53-1003144-01