Brocade 6910 Ethernet Access Switch MIB Reference - Manual (Page 38)

26 Brocade 6910 Ethernet Access Switch MIB Reference
53-1002652-02
3
Performance Monitoring of Loss Measurement Objects
Historic Statistics for Loss Measurement table
The mefSoamLmHistoricStatsTable contains statistics for historic intervals in a Loss Measurement
session.
mefSoamLmCurrentStatsInitiated
Measurements
1.3.6.1.4.1.15007.1.3.1.2.3.1.19
Syntax: Gauge32 Read-only This attribute contains the count of the number of
measurements initiated during this measurement interval.
This attribute applies when mefSoamLmType is lmLmm,
lmSlm, lm1SlTx or lmCcm.
mefSoamLmCurrentStatsComplete
dMeasurements
1.3.6.1.4.1.15007.1.3.1.2.3.1.20
Syntax: Gauge32 Read-only This attribute contains the count of the number of
measurements initiated in this measurement interval that
have completed.
Name, Identifier, and Syntax Access Description
mefSoamLmHistoricStatsTable
1.3.6.1.4.1.15007.1.3.1.2.4
Syntax: SEQUENCE OF
MefSoamLmHistoricStatsEntry N/A This table contains the results for historic Measurement
Intervals in a SOAM Loss Measurement session.
Rows of this table object are created automatically by the
SNMP Agent when the Loss Measurement session is running
and a measurement interval is completed.
Supports 32 completed measurement intervals. If a new
measurement interval completes and must be added to the
table, the oldest completed measurement interval is deleted
(row deletion).
Unless otherwise indicated, the objects in this table are
ignored if mefSoamLmType is 1SlTx.
Except for mefSoamLmHistoricStatsIndex and
mefSoamLmHistoricStatsSuspect, each object in this table
applies only if the corresponding bit is set in
mefSoamLmCounterEnable.
The rows and objects in this table must be persistent upon
reboot or restart of a device.
mefSoamLmHistoricStatsEntry
1.3.6.1.4.1.15007.1.3.1.2.4.1
Syntax:
MefSoamLmHistoricStatsEntry N/A The conceptual row of mefSoamLmHistoricStatsTable.
mefSoamLmHistoricStatsIndex
1.3.6.1.4.1.15007.1.3.1.2.4.1.1
Syntax: Unsigned32 N/A The index for the measurement interval within this PM
session.
Measurement Interval indexes are assigned sequentially by
the SNMP Agent. The first Measurement Interval that occurs
after the session is started is assigned index 1.
This object applies regardless of the value of
mefSoamLmType.
Referential integrity is required, i.e., the index needs to be
persistent upon a reboot or restart of a device. The index can
never be reused for other completed measurement intervals
on the same MEP for a particular PM session. The index
value should keep increasing up to the time that it wraps
around. This is to facilitate access control based on OID.
Name, Identifier, and Syntax Access Description