Brocade FastIron Ethernet Switch Traffic Management Guide - Manual (Page 95)

The following example enables flow control on all priorities and shows the priority-to-PG mapping .
Device(config)# symmetrical-flow-control enable all
Device(config)# show qos priority-to-pg
QoS Internal Priority 0 mapped to Priority Group 7
QoS Internal Priority 1 mapped to Priority Group 7
QoS Internal Priority 2 mapped to Priority Group 7
QoS Internal Priority 3 mapped to Priority Group 7
QoS Internal Priority 4 mapped to Priority Group 7
QoS Internal Priority 5 mapped to Priority Group 7
QoS Internal Priority 6 mapped to Priority Group 7
QoS Internal Priority 7 mapped to Priority Group 7
History
Release version Command history
8.0.10 This command was introduced.
show qos scheduler
Displays information about scheduler profiles.
Syntax show qos scheduler all user-profile-name
Command Default None.
Parameters all
Specifies that information is displayed for all the scheduler profiles configured in the system
and a list of all the ports attached to any scheduler profile.
user-profile-name
Specifies that information is displayed for the specified scheduler profile.
Modes Global configuration mode
Usage Guidelines A scheduler profile must be configured before it can be displayed.
Information can be displayed for a maximum eight scheduler profiles.
Examples The following example displays information for a scheduler profile named user1:
Device(config)# show qos scheduler-profile user1
User Scheduler Profile: user1 Scheduling Option: Weighted round-robin
Ports attached: 1/1/1
Per Queue details: Bandwidth%
Traffic Class 0 1%
Traffic Class 1 1%
Traffic Class 2 10%
Traffic Class 3 10%
Traffic Class 4 10%
Traffic Class 5 10%
Traffic Class 6 20%
Traffic Class 7 38%
show qos scheduler
FastIron Ethernet Switch Traffic Management Guide 93
53-1003093-03