Brocade FastIron Ethernet Switch Traffic Management Guide - Manual (Page 54)

Syntax: [no] rate-limit output sharingvalue priority priority-queue
Specify 0-7 for priority-queue
Configuring outbound rate shaping for a LAG port
This feature is supported on individual ports of a LAG group.
To configure the maximum rate at which outbound traffic is sent out on a LAG port, enter the following
on each LAG port where outbound traffic will be shaped.
device(config)#lag lag1 static
device(config-lag-lag1)#rate-limit output shaping ethe 1/15 651
Syntax: [no] rate-limit output shaping ethernet portvalue
Displaying rate shaping configurations
To display the configured outbound rate shaper on a device, enter the show rate-limit output-
shaping command.
device#show rate-limit output-shaping
Outbound Rate Shaping Limits in Kbps:
Port PortMax Prio0 Prio1 Prio2 Prio3 Prio4 Prio5 Prio6 Prio7
1 - - - - - - - - 651
2 1302 - - - - - - - -
15 651 - - - - - - - -
The following is a sample output from ICX 6650 device.
device#show rate-limit output-shaping
Outbound Rate Shaping Limits in packets/s:
Port PortMax Prio0 Prio1 Prio2 Prio3 Prio4 Prio5 Prio6 Prio7
1/1/1 - - - - - - - - 651
1/1/2 1302 - - - - - - - -
1/1/3 651 - - - - - - - -
The display lists the ports on a device, the configured outbound rate shaper on a port and for a priority
for a port.
Configuring outbound rate shaping for a LAG port
52 FastIron Ethernet Switch Traffic Management Guide
53-1003093-03