Brocade FastIron Ethernet Switch Traffic Management Guide - Manual (Page 83)

Traffic Management Commands
● egress-buffer-profile........................................................................................................ 81
● ip dscp-remark ............................................................................................................... 82
● ip pcp-remark ................................................................................................................. 82
● priority-flow-control..........................................................................................................83
● priority-flow-control enable.............................................................................................. 84
● qos egress-buffer-profile................................................................................................. 84
● qos priority-to-pg............................................................................................................. 86
● qos scheduler-profile.......................................................................................................87
● scheduler-profile..............................................................................................................90
● show priority-flow-control................................................................................................ 91
● show qos egress-buffer-profile........................................................................................91
● show qos priority-to-pg....................................................................................................92
● show qos scheduler........................................................................................................ 93
● store-and-forward............................................................................................................94
● symmetrical-flow-control enable .....................................................................................95
egress-buffer-profile
Attaches a user-configured egress buffer profile to one or more ports.
Syntax egress-buffer-profile profile-name
no egress-buffer-profile profile-name
Command Default If a port is not attached to a user-configured egress buffer profile, it uses the default egress buffer
profile.
Parameters profile-name
Specifies the name of the egress buffer profile to be attached to the port.
Modes Interface mode
Multiple-interface mode
Usage Guidelines The no form of this command removes a user-configured egress buffer profile from the port and the port
uses the default egress buffer profile.
You must configure an egress buffer profile before you can attach it to a port.
Only one egress buffer profile at a time can be attached to any port. You can attach an egress buffer
profile to more than one port.
Examples The following example shows how to attach an egress buffer profile named egress1 to a port:
Device(config-if-e10000-1/1/1)# egress-buffer-profile egress1
FastIron Ethernet Switch Traffic Management Guide 81
53-1003093-03