Brocade FastIron Ethernet Switch Traffic Management Guide - Manual (Page 53)

Output rate shaping on FastIron devices (Continued) TABLE 29
Device Module Minimum Maximum
ICX 6450 All 73 999868
ICX 6650 40 Gbps ports 20 80000000
ICX 6650 10 Gbps ports 20 20000000
ICX 7750 10 Gbps ports 128 kbps 10,000,000 kbps
ICX 7750 40 Gbps ports 8 kbps 40,000,000 kbps
FCX 1 Gbps ports 89 999666
FCX 10 Gbps ports 3388 9996513
FSX SX-FI48GPP module 51 999485
FSX SX-FI-24GPP module 51 999485
FSX SX-FI424P module 651 999936
FSX SX-FI-2XG module 3 9999000
FSX SX-FI-8XG module 3 9999000
Configuring outbound rate shaping for a port
To configure the maximum rate at which outbound traffic is sent out on a port, enter commands such as
the following.
device(config)#interface e 1/2
device(config-if-e1000-2)#rate-limit output shaping 1300
The configured 1300 Kbps outbound rate shaping on port 2 is rounded up to the nearest multiple of the
minimum value on the device.
On ICX 6650, the value is specified in pkts/s.
Syntax: [no] rate-limit output shaping value
Configuring outbound rate shaping for a specific priority
To configure the maximum rate at which outbound traffic is sent out on a port priority queue, enter
commands such as the following.
device(config)#interface ethernet 1/2
device(config-if-e1000-2)#rate-limit output shaping 500 priority 7
The configured 500 Kbps limit for outbound traffic on Priority queue 7 on port 2 is rounded up to the
nearest multiple of 651 Kbps.
On ICX 6650, the value specified is in pkts/s.
Configuring outbound rate shaping for a port
FastIron Ethernet Switch Traffic Management Guide 51
53-1003093-03