Brocade FastIron Ethernet Switch Traffic Management Guide - Manual (Page 12)

What’s new in this document
This document includes the information from FastIron software release 08.0.10b.
Summary of Enhancements in FastIron release 08.0.10b TABLE 1
Feature Description Location
A new command has been added:
store-and-forward .
The store-and-forward command
changes the switch mode to store-and-
forward.
See store-and-forward on page
94.
Support for Outbound rate
shaping. Outbound rate shaping is supported
on ICX 7750 devices. See Configuring outbound rate
shaping for a LAG port on page 52
and Configuration notes for rate
shaping on page 50.
How command information is presented in this guide
For all new content, command syntax and parameters are documented in a separate command
reference section at the end of the publication.
In an effort to provide consistent command line interface (CLI) documentation for all products, Brocade
is in the process of preparing standalone Command References for the IP platforms. This process
involves separating command syntax and parameter descriptions from configuration tasks. Until this
process is completed, command information is presented in two ways:
• For all new content included in this guide, the CLI is documented in separate command pages.
The new command pages follow a standard format to present syntax, parameters, usage
guidelines, examples, and command history. Command pages are compiled in alphabetical order
in a separate command reference chapter at the end of the publication.
• Legacy content continues to include command syntax and parameter descriptions in the chapters
where the features are documented.
If you do not find command syntax information embedded in a configuration task, refer to the
command reference section at the end of this publication for information on CLI syntax and usage.
What’s new in this document
10 FastIron Ethernet Switch Traffic Management Guide
53-1003093-03