beautypg.com

Clearing acl and rate limit counters, Viewing traffic policies – Brocade FastIron Ethernet Switch Traffic Management Guide User Manual

Page 75

background image

ACL and rate limit counting statistics

TABLE 32

Parameter

Description

Traffic Policy

The name of the traffic policy.

General Counters

Port Region #

The port region to which the active traffic policy applies.

Byte Count

The number of bytes (packets in ICX 6650) that were filtered (matched ACL clauses).

Packet Count

The number of packets that were filtered (matched ACL clauses).

Rate Limiting Counters

Port Region#

The port region to which the active traffic policy applies.

Green Conformance

The number of bytes (packets in ICX 6650) that did not exceed the CIR packet rate.

Yellow Conformance

The number of bytes (packets in ICX 6650) that exceeded the CIR packet rate.

Red Conformance

The number of bytes (packets in ICX 6650) that exceeded the PIR packet rate.

Clearing ACL and rate limit counters

The Brocade device keeps a running tally of the number of packets and the number of bytes per packet
that are filtered by ACL statements and rate limiting traffic policies. You can clear these accumulated
counters, essentially resetting them to zero. To do so, use either the clear access-list accounting
traffic-policy command
or the clear statistics traffic-policy command.

To clear the counters for ACL counting and rate limit counting, enter commands such as the following.

device(config)#clear access-list accounting traffic-policy CountOne

device(config)#clear statistics traffic-policy CountTwo

Syntax: clear access-list accounting traffic-policy TPDname

or

Syntax: clear statistics traffic-policy TPDname

The TPDname is the name of the traffic policy definition for which you want to clear traffic policy
counters.

Viewing traffic policies

To view traffic policies that are currently defined on the Brocade device, enter the show traffic-policy
command. The following example shows displayed output. The following table explains the output of the
show traffic-policy command.

device#show traffic-policy t_voip

Traffic Policy - t_voip:

Clearing ACL and rate limit counters

FastIron Ethernet Switch Traffic Management Guide

73

53-1003093-03