Yokogawa DA100 - Manual (Page 89)

IM DA100-11E 8-8
Write the Setting Data to DA100
Read out the setting data from floppy disk, display them on CRT of the personal computer, and write
them to DA100.
10 ‘
20 OPEN “COM1:E81N” AS #1
30 OPEN “TS1.DAT” FOR INPUT AS #2
40 ‘
50 PRINT #1,CHR$(&H1B)+”O 01"
60 LINE INPUT #1,D$ :PRINT D$
70 LINE INPUT #2,D$
80 IF LEFT$(D$,2)=”EN” THEN GOTO 150
90 PRINT #1,D$
100 PRINT D$
110 LINE INPUT #1,D$
120 IF LEFT$(D$,2)=”E1" THEN PRINT “SYNTAX ERROR”
130 GOTO 70
140 ‘
150 PRINT #1,CHR$(&H1B)+”C 01"
160 LINE INPUT #1,D$ :PRINT D$
170 CLOSE
180 END
Output the Unit and Decimal Point Data
Read out the unit and decimal point data from DA100, display them on CRT of the personal computer,
and save them to floppy disk.
10 ‘
20 OPEN “COM1:E81N” AS #1
30 OPEN “TS2.DAT” FOR OUTPUT AS #2
40 ‘
50 PRINT #1,CHR$(&H1B)+”O 01"
60 LINE INPUT #1,D$ :PRINT D$
70 PRINT #1,”TS2"
80 LINE INPUT #1,D$ :PRINT D$
90 PRINT #1,CHR$(&H1B)+”T”
100 LINE INPUT #1,D$ :PRINT D$
110 PRINT #1,”LF001,010"
120 LINE INPUT #1,D$
130 PRINT D$
140 PRINT #2,D$
150 IF MID$(D$,2,1)<>”E” THEN GOTO 120
160 ‘
170 PRINT #1,CHR$(&H1B)+”C 01"
180 LINE INPUT #1,D$ :PRINT D$
190 CLOSE
200 END
8.3 RS-422-A/RS-485 Sample Programs