Yokogawa DA100 - Manual (Page 73)

IM DA100-11E 7-8
7.8 A/D Calibration Data Output Format
A/D calibration data are output in the following format by the TS8 + “Device Trigger (GET)” + LF
command: This is effective only in the A/D calibration mode.
XZ A/D calibration data for the last slot
EN Output completion CrLf
CrLf
XZ
CrLf A/D calibration data for the first slot
Calibration data are output for every slot after the command to execute A/D calibration. The output
format is the same form as in the XZ command setting shown below.
XZ subunit number, slot number, CAL/EXEC, calibration itemCrLf
All calibration items are output.
Range of outputting
The number of slots to which A/D calibration data are output is determined by the channels specified
by the LF command. For example, if channels 042 to 236 are specified by the LF command, data
from subunit 0, slot 4 to subunit 2, slot 3 are output.