Yokogawa DA100 - Manual (Page 47)

IM DA100-11E 5-5
Command Format
5
5.4 Command List
Setting Command
Command Content Effective mode
SR Range setting Operation mode
SN Unit setting (scale unit) Operation mode
SA Alarm setting Operation mode
SD Date and time setting Operation mode
SV Moving average setting Operation mode
SY Setting of copy between channels of channel-set parameters Operation mode
SX Group setting Operation mode
SI Timer setting Operation mode
SQ Match time setting Operation mode
SL Event/action setting Operation mode
SO Computation expression setting (optional) Operation mode
SK Computation constant setting (optional) Operation mode
CM Communication input data setting (optional) Operation mode
XV Sample rate setting Setup mode
XI A/D integration time setting Setup mode
XQ Filter setting Setup mode
XA Setting related to alarm Setup mode
XY Relay reflash setting Setup mode
XN Relay AND/OR setting Setup mode
XD Relay energizing/deenergizing setting Setup mode
XH Relay hold setting Setup mode
XB Burnout setting Setup mode
XJ Reference junction compensation setting Setup mode
XG Setting of computation error handling methods (optional) Setup mode
RO Setting the hourly, daily and monthly reports and the time to Setup mode
create the report
RM Setting of the report channel Setup mode
RI Setting the print setting which is applied at report creation time Setup mode
VS Selects the relay that can be turned ON/OFF externally. Setup mode
XE Setup setting data establishment Setup mode
XT Setting of temperature unit Setup mode
XZ Setting for execution, data modification, and data storage in A/D calibration mode
module in A/D calibration
Control Execution Command
Command Content Effective mode
AR Alarm reset Operation mode
IR Timer reset Operation mode
EX Computation start/stop/reset/clear Operation mode
BL Executing the initial balancing Operation mode
DR Report start/stop Operation mode
RS System reconstruction Operation mode
RC RAM clear (initialization of operation mode setting parameter) Operation mode
DS Setting mode selection All modes
VD Turn ON/OFF the relays specified by the VS command. Operation mode
TS Selection of talker output data All modes
FM Measured data output request Operation mode
RF Report output request Operation mode
LF Setting data output request All modes
CF System configuration data output request All modes
VF Requests the output of the relay condition. Operation mode
BO Byte output order specification Operation mode
IM Interrupt mask specification Operation mode
SM Axuiliary mask specification Operation mode
Note
• The execution of a command in a mode different from the effective mode will cause a syntax error. Select a mode in which
the command is effective using the DS command and do the setting and execution.