Yokogawa Standalone MW100 - Manual (Page 44)

Then select the ―Connection Tab‖……
Enter the ―Requested Packet Interval (RPI)‖ for the application. The default is 10.0ms. This value will be based on the
EtherNet IP network traffic and may need to be adjusted based on the application requirements. Press ―OK‖ when
finished.
The MW100 Implicit (I/O) Configuration is complete and MW100 Tags are automatically created in the ―Controller Tags‖
area……(Note: Descriptions must be entered manually).
The MW100 Measurement Channels are now available for use in logic programs. The next step is to send the 1769-IT6
Channels 0 thru 5 to the MW100 Channels C01 thru C06. This is accomplished via a ―COP‖ instruction in logic. Refer to
example below……
41