Yokogawa Standalone MW100 - Manual (Page 25)

The MSG Read instruction on Rung 0002 is configured as follows:
Type – Peer-To-Peer (default value, cannot be changed)
Read/Write – Read
Target Device – 500CPU
Local/Remote – Local
Control Block – N10:51
In the ―This Controller‖ area, enter the starting data table address for the data to be received (F8:0), the Size in Elements
(number of data words) (10), and the Channel (1 for Ethernet). In the ―Target Device‖ area, enter the starting data table
address of the DX Advanced (F10:0 for Measurement Channel C01). In the ―MultiHop‖ selection box, select ―Yes‖. Th
en
click on the ―MultiHop tab at the top of the Setup Screen.
In the ―To Address‖ area, enter the IP address of the DX Advanced (192.168.1.100). Then click on the close window (X) at
the top right of the Setup Screen (the screen can also be closed by clicking on the ―Setup Screen‖ In the MSG instruction.
The MSG Read from the DX Advanced is now complete.
22