Yokogawa Standalone MW100 - Manual (Page 36)

Configure the channel as follows:
Driver - select “DF1 Full Duplex”.
Baud – select “38.4K”
Parity – select “None”
Stop Bits – select “1”
Source ID – In this example, the SLC 5/04’s DF1 address is “1”
Under the ―Protocol Control‖ area, enter the following:
Control Line – select “No Handshaking
Error Detection – select “CRC”
Embedded Response – select “Enabled”
Duplicate Packet Detect – check the box.
When finished, click ―OK‖. The SLC 5/04 channel configuration is complete.
33